ZHF series deinking waste water processor
With the high-speed development of national economy, the government
is becoming more and more high to the requirement of environmental
protection, responsibility for pollution control of waste paper
deinking pulp enterprises is becoming more and more heavy. For we
are engaged in environmental protection machinery manufacturing
enterprise is a huge challenge and opportunity. We are determined
to seize the opportunity, actively carry out for purification of
waste paper deinking pulp wastewater, chemical raw materials and
reuse, recycling paper pulp of new technology and equipment
research. Take to closed cycle deinking pulp wastewater reuse,
coarse slag, such as water ink gutter water by the physicochemical
and biochemical treatment of COD content below 100 mg/l, emissions
under 10 m after tons of pulp, reached the international technical
level. Flotation deinking is the premise and foundation of middle
wastewater reuse. Waste plastics, rubber, adhesive, printing ink,
in the paper pulp packing for papermaking harmful material such as
after flotation deinking system directly in the form of solids
separation, water and water of alkali, surfactant, heat is
beneficial to pulping material, recycling front, to the process is
to save water and save chemicals. A small amount of water is
harmful to the pulp and paper material back to the process and the
deinking machine processing it won't produce the phenomenon of
vicious circle, directly generate economic and social benefits.
ZF series waste water processor is my company developed under the
environment of a new generation of pulping wastewater purification
recycling equipment, it integrated the design features of waste
paper pulping waste water purification machine at home and abroad
and technological advantages, has low energy consumption, high
removal rate of impurities such as ink, less wastage fibre, the
advantages of convenient operation, is ideal for waste paper
pulping ZhongDuanShui processing equipment.
The main structure and working principle
This equipment is mainly composed of cylindrical tub, spray foam
generator and other parts.
Cylindrical tank is used for removing ink in the waste water
solutions provide necessary space.
Spray foam generator is inhaled air and waste water slurry mix.
Waste water through the pump to a 0.05-0.10 Mpa pressure to spray
foam generator, special structure of the injection foam generator
make the air inhaled and fully mixed with waste water, gas quickly
to catch the bubble catch the wastewater of printing ink, adhesive,
and lightweight materials such as film, ash floating to the surface
concentration and collected from ink mouth eduction.
Advantages and main performance
1. High flotation efficiency
Flotation rate can reach 99%, the single ZF series ink and fiber in
waste water waste water processor can complete complete separation.
2. The separation ability to ink
Can remove larger particles ink, adhesive (5-500 - um).
3. Low energy consumption wastewater processing
Only single device equipped with two sets of pump, the installed
capacity is low.
4. The fiber loss less
Fiber attrition rate 0.5% or less.
5. Waste water processor is easy to operate, tub clean easily.
6. The repair rate is extremely low, 1-2 years to replace a jet
foam generator.